![]() UPnP process may have stopped in the camera so power cycle the camera (turn off then back on). ![]() This is probably a connectivity problem and you should go back up to the "Check hardware" section again. The other software that I am using is Blue IRIS, Netview, IP Camera.etc all have motion detection and alerts, but they detect every movement, or example in the. If you are seeing a yellow LED, it means the camera has no IP address and is not seeing the DHCP server or Alert Commander.Turn off any Firewalls or Antivirus programs which can sometimes block the signal.Make sure you are not using the same password with different HomePlug devices. Are there other 3rd party HomePlug devices on the network that are already assigned passwords? Another bridge, lighting control, etc? This could block the camera's signal.Try the camera using different electrical outlets.This will help to verify if signal strength is an issue. Plug the camera into an electrical outlet close to where your router is located.Check that Alert Commander is running using the latest version of software.Is your computer turned on and connected to network.Is the router powered on and functioning?.Check cables and all network connections.Is the camera plugged into the network? (either HomePlug or PoE).To do this, unplug the camera power supply from the AC power outlet and then plug it back in. Try to power cycle the camera (turn on and off).Is the camera plugged in, has power and the LED is lit?.If Alert Commander does not detect your camera, please check the following: System Requirements Support KEY FEATURES COMPLETE CONTROL ON THE GO.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |